Packet Tracer – Connect a Router to a LAN Addressing Table Objectives Part 1: Display Router Information Part 2: Configure Router Interfaces Part 3: Verify the Configuration Background In this activity, you will use various show commands to display the current state of the router. You will then use the Addressing Table to configure router Ethernet interfaces. Finally, you will use commands to verify and test your configurations.
220.127.116.11 Packet Tracer – Connect a Router to a LAN Packet Tracer – Connect a Router to a LAN (Answer Version) Answer Note: Red font color or gray highlights indicate text that appears in the Answer copy only. Packet tracer library for Routing and Switching Essentials (CCENT). 2 commits 1 branch 0 releases. New pull request. Clone or download.
Note: The routers in this activity are partially configured. Some of the configurations are not covered in this course, but are provided to assist you in using verification commands. Part 1: Display Router Information Step 1: Display interface information on R1. Note: Click a device and then click the CLI tab to access the command line directly. The console password is cisco. The privileged EXEC password is class.
Which command displays the statistics for all interfaces configured on a router? R1#show interfaces b. Which command displays the information about the Serial 0/0/0 interface only? R1#show interfaces serial 0/0/0 c. Enter the command to display the statistics for the Serial 0/0/0 interface on R1 and answer the following questions: 1) What is the IP address configured on R1? 2) What is the bandwidth on the Serial 0/0/0 interface? Password: cisco R2>en Password: class R2#configure terminal R2(config)#interface gigabitEthernet 0/0 R2(config-if)#ip address 10.1.1.1 255.255.255.0 R2(config-if)#no shutdown R2(config-if)#description LAN connection to S3 R2(config-if)#exit R2(config)#interface gigabitEthernet 0/1 R2(config-if)#ip address 10.1.2.1 255.255.255.0 R2(config-if)#no shutdown R2(config-if)#description LAN connection to S4 R2(config-if)#exit R2(config)#exit R2#ping 10.1.1.10 Type escape sequence to abort.